How To Put On Kong Dog Harness: 5 Easy Steps To Putting On A Padded Dog Harness

how-should-a-harness-look-on-a-dog-1
Before you start, double-check that the harness you are using is right for the size of dog you have. It will either be too tight or slip off over your dog’s paws if it isn’t the right size.
Assuming you have the proper harness, make sure your dog is relaxed before proceeding with these simple steps.

1. slither your dog’s head in it.

Owners of padded overhead harnesses should gently slip their dog’s head through the neck piece. If you have a step-in model, you should unbuckle it and lay it on the ground so your dog can step over it.
Pulling on your dog’s head or making them excited is not a good idea. You don’t want them to associate negative emotions with their harness because that will make them less likely to wear it.

2. fasten the bottom straps.

Pull the bottom strap under your dog’s belly, then the top piece over his back. Some harnesses with a lot of padding will be difficult to maneuver, but getting into place shouldn’t be too difficult.
If you have a padded harness with this type of marking, you’ll want to pay attention to which loop corresponds to which foot. While you’re doing this, talk quietly to your dog so they don’t get worked up and lose one of the straps.

3. Tighten the side straps.

Encourage your dog to step through the loop on the harness and then clap the side straps together to make the harness snug but not uncomfortable. Newer padded harnesses can be difficult to connect on both sides, so double-check that you haven’t undone the harness by trying to connect the other side.
It may take a few tries, but you don’t want the harness to come off as soon as you’ve finished. If your dog becomes excited during this step, calm them down because it will be difficult to get the harness on otherwise.

4. fine-tune the harness

Put your fingers under the front of the padding to see if there’s enough room for your dog to move around in it, and if there isn’t, adjust it. While padded harnesses are generally more comfortable and safer than traditional harnesses, if you don’t adjust them properly, your dog may experience skin irritation.
Slide each side of the strap with your index and middle fingers. If the gap isn’t between 2-4 inches, there’s a problem: your dog’s harness is either too tight for the dog or too loose, causing it to fall off.
Uncomfortable dogs may make a noise or make a small motion to show that they don’t like the way their harness is put on. Never ignore these warning signs, as they may be the only response you’ll get to show that something is wrong.

5. Attach a Leash

Allow your dog to run free by clipping your leash to the back of the padding. Most dogs will figure out when it’s time to move, but if yours doesn’t want to at first, don’t be afraid to give him or her a chance.
As strange as it may sound, some dogs may appear embarrassed the first time they try on a harder setting. This is especially true if they’ve grown accustomed to walking with a lighter load.
If this happens, lay on the charm and get them excited about going outside. Usually, they’ll get the message.

How Do You Put On A Padded Dog Harness Correctly?

Place the padded harness on your dog’s rib cage and neck to make it as comfortable as possible. It’s best to start when your dog is calm and standing or sitting at attention.
Always carefully slip the harness over your dog’s head, making sure that any D-rings face back. This is how you’ll know if the harness is properly oriented.
Always use the included adjuster to thread the straps of your harness. While it may be tempting to simply move the harness back and forth until it fits, you could end up loosening it too much.
If you can’t get the buckles to sit right, loosen the straps. You’ve most likely got the harness on correctly once it latches in place.

How Do You Put a Harness on a Kong Padded Dog?

Kong padded harnesses are similar to other step-in harnesses in that they are easy to put on. Lay the Kong harness out and have your dog stand over it after unbuckling it.
Place one of their paws in each loop and raise the harness by snapping the strap buckles together. It should be able to stay in place without causing discomfort.
Kong harnesses should fit better than other padded harnesses because they have an extra piece of padding in the front. For maximum comfort, adjust it so that the pad faces directly in front of your dog.

Is a Padded Dog Harness Too Tight?

A padded dog harness should be snug enough to keep your dog in place while walking but not so tight that it is uncomfortable. You should be able to easily slide your index and middle fingers underneath the straps on either side.
If you have a lot of resistance or can’t slide your fingers in side-by-side, the harness is probably too tight. Pull the belly strap up or down until it’s the right size for your dog and he’s comfortable with it.
When the harness is tight on your dog’s chest but loose around the rest of his or her body, you know you’ve got it on right.